Pulser Receiver



PRC50 – Pulser Receiver Card


PRC50 – Pulser Receiver Card The PRC50 is a versatile single-channel Pulser-Receiver on a half-length PCI card. It is ideal for use in PC-based ultrasonic testing and inspection systems, and its small size and low power consumption enable systems to be implemented using portable computers. The PRC50 is provided with turnkey control software for Windows. A Software Development Kit and Programmer’s Manual are provided for the development of custom applications.

The PRC50 can be combined with A/D Boards or other signal detection and processing instrumentation, which gives system integrators the flexibility to optimize system cost and performance. The full-featured PRC50 is an excellent choice for PC-based ultrasonic system applications including flaw detection, quality assurance, material characterization, transducer testing, and time of flight measurements.


DOWNLOAD BROCHURE


DPR300 Family


DPR300 Family The DPR300 is a computer controlled ultrasonic pulser/receiver with an extremely low noise receiver. Instrument controls include receiver gain, high and lowpass filter cutoff frequency selection, pulse energy, pulse amplitude, pulser impedance, damping level, pulse-echo or through transmission mode select, pulse repetition rate, and pulser trigger source select. A Manual Control option is available.

The DPR300 includes a turnkey software front panel control program to enable immediate usage in your application. A Windows control application and Windows SDK are provided to enable rapid development of custom software.

Areas of application include computer-controlled imaging and measurement systems, NDE systems, research & development, materials analysis and inspection, transducer evaluation, and exacting low-noise measurement systems.


DOWNLOAD BROCHURE


DPR500 Family


DPR500 Family The DPR500 DUAL Pulser/Receiver is the first dual channel, modular instrument consisting of two complete pulser/receivers integrated into one unit. Receiver modules are currently available in the following bandwidths: 500 MHz, 300 MHz, and 50 MHz. The DPR500 may also be configured as a single channel instrument using any of the available modules. Instrument functions include adjustable damping, gain, pulse amplitude, pulse energy, pulse repetition rate, high pass filters, low pass filters, echo or through mode select (dependent on pulser selection), and pulser trigger source.

The DPR500 includes a Windows-based software control program.A Windows SDK is provided to enable rapid development of custom software.

The DPR500 utilizes remote pulsers. This approach enables the pulser to be located in close proximity to the transducer. By eliminating long lengths of cable between the pulser and transducer, cable effects that can produce undesirable reflections and ringing are minimized. Avariety of interchangeable remote pulsers are available to accommodate a wide range of transducer frequencies and energy requirements.

Applications include acoustic microscopy, thin material or coating thickness gaging, computer controlled imaging and measurement systems, materials analysis and characterization, and transducer evaluation.


DOWNLOAD BROCHURE


Remote Pulsers


Remote Pulsers When your application requires the transducer to be located at a distance from the receiver, or uses a transducer with a center frequency greater than 50 MHz, there are a number of significant performance advantages gained by minimizing the cable length between the pulser and the transducer. In these applications, remote pulsers and remote pulser/preamps exhibit outstanding performance, and provide substantial improvement in system flexibility.



DOWNLOAD BROCHURE



JSR Ultrasonics supplies a wide array of accessories to enhance the performance of your JSR UltrasonicsPulser/Receiver.


Accessories:

  • A/D Digitizing Boards
  • Data Acquisition and Signal Processing Software
  • Multiplexers
  • Distance Amplitude Correction (DAC) Boards
  • Transducers
  • Rack Mounting Kits
  • Cables